Heat transfer processing is a complex and highly technical work. There are no fewer than ten kinds of hot stamping objects, and their properties are different. There are many hot stamping materials. The effect of hot stamping on each type of product and each batch of work is very good. The ideal is hard. Therefore, in addition to selecting materials according to requirements, it is also necessary to pay attention to the correct processing when processing, in order to ensure the quality of the binding. The phenomenon of these problems was analyzed separately on some hot stamping issues that have emerged, and solutions have been proposed.
1, hot flower or hot stamping is not strong:
a. Light pressure or low temperature. - Increase pressure or increase temperature, time
b. The hot stamping material is not in conformity with the object to be heated - use the right stamping material
2, after the hot stamping dull, paste version is not clear: hot stamping temperature is too high, excessive pressure - lower temperature, reduce stress
3, the same version of the pressure after stamping: graphic area size disparities, uneven pressure - a large area of ​​graphic pressure, can be used to adjust the method of padding, to adjust the size of the area of ​​pressure is equal
4, not hot or burnt off:
a. The hot stamping material is not in conformity with the object to be heated. - Use a suitable hot stamping material
b. The quality of the stamping material is poor - temporarily change the quality and check its quality
c. The temperature is too low and the pressure is too low - readjust the temperature and pressure
d. Helpless adhesives or excessive dusting during printing - Use of binders to remove the same material for printing and dusting, normal
5, hot stamping in good times and bad:
a. Unstable material quality - check material quality, temporarily replace and record
b. The temperature or pressure is abnormal - check the temperature, time, pressure, and adjust the hot stamp
6. The broken lines of graphic lines are not clear:
a. The embossing of the stamped material is too large - the pattern fabric with bumps and depressions should not be hot stamping thin line pattern
b. Too light pressure - increase pressure and temperature make up
7, after the stamping leak:
a. Too deep stamping pattern - increase pressure
b. low pressure, low temperature - increase the temperature 5 °C
8. The edges and corners of handwriting after hot stamping are not obvious:
The edges of hot stamping or hot stamping are not prominent -
a. Check whether the hot stamp graphic is marked before stamping, and repair it if it fails.
b. Place the corners of the writing on the lower plate and make it concave
Source: Wuhan Xinyi Creative Base
- Lightweight construction to avoid airline fees
- 360 degree enhanced wheel system so you can glide through the airport effortlessly
- Ergonomic handle grips allow for maximum control of your suitcase while traveling and moving through crowded airports
- Fully expandable to ensure maximum packing capacity
- Beautiful designer pattern to keep you styling on the go
Four Universal Wheeled Trolley Luggage
Four Universal Wheeled Trolley Luggage,Four Wheeled Trolley Luggage,Aluminum Trolley Luggage,High Capacity Wheeled Trolley Luggage
Jiangxi Jizhirui Luggage CO.,Ltd. , http://www.jxjzr.com