There are many fishing methods in the world, and the preferences of the fishing folks across the country must be different, but there must be a group of people who love night fishing. The darkness of the night, the unknown catches, the floating stars, all of which are intoxicating. At night, when watching drifter catching fish, the choice of fishing friends varies. Some people use night fishing lights and others use electronic luminous float. However, in the real wild fishing environment, most people will choose luminous rods and floating floats. Fishing, because the luminous stick is more subtle than other methods, so that the fish's alertness is not so strong, fishing in the wild at night is more suitable.
First, the choice of float
When choosing a floating float with a luminous stick, it is best to choose a hard-tailed float with a center of gravity in the lower part. Sizes 2 and 3 are preferred. It should be noted that, after the float is equipped with a luminous rod, the movement must be changed. The added luminous rod makes the tail float heavy. For a long time, the combination of the drift tail and the body is easy to crack, so it is not recommended to choose high-grade and expensive floats. There is also the importance of the thickness of the tail, it is recommended to use fine sandpaper to fine sand, which is also the key to improving the sensitivity of night fishing floats.
Choose a good float, put on a luminous hook into the water to look over and turn over. If you cannot turn over or turn over too long, it is recommended to subtract 1-3 mesh from the tail. When the glow stick is installed, the plastic tube or rubber sleeve should be cut into 3 thin rings, and only three thin rings can be set to fix the luminous rod, and the weight of the floating head should be reduced as much as possible.
Second, adjust and drift
Roughly look for the bottom: In order to improve the accuracy of floatation, do not install strands first, look for the luminous rods flush with the surface of the water, be sure to fall to the end, and then drop the float 40 centimeters or so, that is, exceed the length of the strands, install the strands, and start to adjust Drifting, the advantage of doing this is that once it is determined, the eyesight will not change anymore, half-water drift, with the increase of water depth, the eyesight may change, and it is more troublesome to correct it during night fishing.
Adjusting and drifting: The patient's trimmed lead skin to the luminous stick exposes the water surface, so that the reflection distance is about 1.5 luminous rod lengths. At this time, the number of tails is not important, and the rod is used to display the target. Blind changes: Under normal circumstances, when the bait is angling, the luminous reflection between the exposed part of the water surface and the reflection of the water surface is about half the length of the luminous rod, and the lower hook can be determined exactly. The short strand is relatively straight and the fishing group is relatively straight. More sensitive, as long as the luminous reflection combined or opened more than 1.5 luminous rod distance, you can raise your eyes, obviously.
However, in the case of low temperature or poor fish eating conditions, the floating action is very small, then how to regulate the movement or enlarge it? Very simple, adjust the position of the luminous stick in the tail:
Because the luminous rod is covered with three plastic rings on the tail of the float, so if the half-height target is adjusted, for example, adjust the 5 head, adjust the brightness rod as long as the pull down to 4 multi-point position, the reflection spacing in 2 Luminous rod length or so, loaded bait fishing a luminous rod length, then the psychological knowledge is to catch more than a 4 or 5 heads, spacing is small, small movements can be seen out, visually acceptable. As long as you move the luminous position in the tail, you can call up any desired state.
Whether it is to choose floats or floats, it has a great influence on the use of the glow sticks. If used properly, the glow sticks will never lose to electronic floats and fishing lights in night fishing. I hope this article can give fishers some inspiration. .
Electric Patient Lift
The electric patient lift realizes the safe transfer of paralyzed or injured patients or the elderly between beds, wheelchairs, seats, and toilets, which greatly reduces the work intensity of nursing staff, improves nursing efficiency, and reduces nursing risks. It can solve the movement, weighing and positioning control of the DPS patient's body position for the elderly, the disabled, the paralyzed patients, and the bedridden patients.
Features of medical Transfer Patient Lift
The caster legs can be adjusted arbitrarily within the range of 0°-38°, which is suitable for the angular needs of various wheelchairs, seats, toilets and hospital beds.
The height between the pillar and the lifting rod of the electric lift can be adjusted as needed (adjustment distance 0mm-50mm-100mm), and it can be lifted from the ground to a suitable position.
The electric lift has a safety emergency stop device.
During the lifting process, the patient can rotate 360° arbitrarily in order to obtain the best posture during transfer.
The push handle of the electric lift conforms to the principle of dynamics, which is convenient for pushing forward and backward or moving and rotating sideways.
The rear wheel is equipped with a brake device to prevent the lift from sliding when the patient is lifted, causing unreasonable injury to the nursing staff or the patient.
Electric Patient Lift,Patient Lift Hoist,Electric Mobile Patient Lift,Electric Sit To Stand Lift
Jiangmen Jia Mei Medical Products Co.,Ltd. , https://www.jmjiameimedical.com