Automatic stencil machine detailed operation steps

an examination:

* First of all, check whether the electrical part has fallen off and whether the external power supply is ~220V.

* Before starting the machine, make sure whether there is syrup or water in the tank. Waterless start will burn the heater and circulating motor.

* Roller. Whether the water spray pipes are positioned or not, and whether the drying fan protection net is covered.

Boot:

Press the ON/OF button once, the indicator light will show that it is ready to be flushed, and the temperature of the developer will automatically rise to the set temperature after starting up. At this point, the circulation system will start to operate; if the actual liquid temperature has reached the set temperature If the temperature exceeds the set temperature, the recirculating water jet system will not operate and will be in a stationary state.

Shutdown:

Press the ON/OF button once, the indicator lights up and shuts down, and the sprinkler system is turned off. The drying system drive system stops.

Entrance:

The PS plate to be developed is inserted from the A inlet;

No need to develop the PS plate from the B entrance;

Glue or not can be controlled by the red switch on the panel. I is for gluing, and O is for gluing.

Reading of data:

Display temperature: Press the button for the development temperature once to read the development temperature. At this time, the number displayed on the display is not blinking, which is the actual temperature of the liquid. Then press the temperature button again, and the number displayed on the display is blinking. , is the user's set temperature.

Bake temperature: just like the temperature, press this button once, when the word is not flashing, it is the actual drying temperature; when you press it again, the word flashes, that is, the temperature required by the user is set.

Number of editions: Press this button once to display the number of sheets that have been punched on the display. If you want to return to zero, press this key once, and then press it three times quickly. The version number will be zeroed.

Speed: Press this button once, the flashing number on the display is the user's set speed, the number is 20~40 adjustable, 20 is the fastest, and 40 is the slowest. Press this button once, and then press it three times quickly. The displayed flashing number is the flow set by the user. That is to say, the time when the punching plate starts to completely leave the plate processor, if the plate is not completely out of the machine. To stop, it means that the user setting process is too short. If the stencil has been completely left for a long time, but the machine is still running, the flow setting is too long.

Supplement: Press this button once, the displayed flashing number is the user's setting for each pot to automatically replenish the potion unit, and the flashing digital user can increase or decrease as required. Press three times continuously, ie manually The supplement, the motor is ready to add the potion.

Reversal: Press this key once to stop the ongoing process of clinching immediately. Like RESET, the version that advances after five consecutive seconds will exit.

Changes to the data:

Change the temperature: press the temperature key, the display digit flashes, then press the + or - the displayed number is changed with the user's needs, if you press the accelerator key and the + or - key, the change in the displayed number, that is, multiple Change to achieve rapid change.

Change the baking temperature, speed, flow, etc. The method of supplementation is the same as the temperature display mode. The operation method is the same.