The fourth generation of dark color transfer material use method

Structure introduction:
This material consists of fabric and oily paper. We mainly transfer the image to be transferred onto the fabric side.

advantage:
1, combined with the fabric, the softness is particularly strong, there is no third deep-colored transfer paper after the transfer of rubber hard feeling;
2, strong adhesion, can be firmly integrated with the cotton fabric;
3, ink absorption is strong, regardless of printing or transfer printing, the ink does not spread, not blooming, bright color, good reducibility;

Here we introduce this method of operation method one:
With the "sublimation transfer paper" transfer (the method has the advantage of easy operation, good effect) or use "photo quality inkjet paper" instead.
Step 1. Invert the image in the image processing software.
Step 2. In the printer setup, use image quality or photo quality (720 dpi or 1440 dpi) to print the image to be transferred on the “sublimation transfer paper”.
Step 3. Use scissors to cut off the blank area, leaving only the part of the image you want.
Step four, the machine's temperature is set at 190 degrees, the time is set at 60S, waiting for warming.
Step 5: Take out the dark brown transfer material of AIR WAVES, lay on the top of the machine table, and the fabric faces up (in the direction of the heating plate).
Step 6: Place the previously prepared “sublimation transfer paper” with images on top of the dark brown fabric of the fourth generation (the image is on the fabric side, just like the light-colored direct transfer of light-colored garments. place).
Step 7 Confirm that the "sublimation transfer paper" and the fourth-generation dark paper have been placed, press the machine handle, wait 60 seconds, lift the machine handle, remove the dye-sublimation paper, and then use the scissors to blank the edges of the fourth-generation paper image The place is cut off.
Step 8. Put the garments or backpacks to be transferred onto the top of the machine table and press the handles of the machine to go to the garments.
Step 9. First, remove the oily paper behind a small portion of the fourth-generation dark paper, reveal the white plastic surface behind it, and after confirming the position, remove all the oily paper behind.
Step 10. Place a sheet of cover paper on the pattern to cover the pattern. The pressure of the machine is adjusted properly and the machine handle is pressed down. . . Wait 8S, lift the machine handle and complete the entire transfer process.

Method Two:
With the "AW light-colored transfer paper" transfer (the advantage of this method is easy to operate, the best effect, but the cost is high), the rest of the steps are shown in method one. This method is costly. If the customer wants to achieve the best results, this method is feasible.

Method 3: The AIR WAVES 4th generation dark transfer paper is directly printed with thermal transfer ink, and lay down the 4th generation of paper on the desired medium. See the supplementary instructions in Article 2 and place the fabric on the surface to isolate it. Paper, and then press down on the machine handle, this transfer method and the third generation, but the color will be slightly lighter. This method is not recommended.

Separation paper selection: You can use AIR WAVER dark-colored release paper, or locally purchased stickers to use the oily paper behind it.

Supplementary explanation:
1, please be sure to wash after 24H and wash the clothing over.
2. When placing the 4th-generation paper to the printed medium, separate the fabric and the paper from the top to the bottom. Stick the small part first to the place where the pattern is to be printed. Hold it down with one of the hands. The other part of the hand peels off the rear oily paper. When printing, it is covered with a release paper. The machine is set to 8S.